The fire pit and the outdoor kitchen look just lovely. However, a hot tub would be the ultimate in relaxation. Do you need an electrical contractor in Jonesboro, or can you save money and do it yourself?
Plug-in Hot Tubs
Plug-in hot tubs use any 120-volt plug. The main benefit of plug-in hot tubs is mobility and the fact that the pump generates plenty of bubbles. The downside is that they don’t heat as fast as one wired directly to the breaker box. Homeowners can do this themselves. However, to avoid injury, you should contact an electrical contractor.
Wired Hot Tubs
You should know about wiring before trying to wire a hot tub. Wiring a hot tub to the breaker box produces more heat faster in the hot tub. It involves first knowing the route between the hot tub and the breaker box. Next, a conduit and wiring are run from the breaker box to a GFCI–or Ground Fault Connection Interrupt–box between the power source, like a plug and the hot tub. This box must be seen from the hot tub.
It’s important that a qualified electrical contractor in Jonesboro wire the box according to the National Electric Code and all state and local codes. There is a code written specifically to keep installers and owners safe.
Dedicated circuits in the breaker box must be established to avoid overloading the breaker box. A clearly labeled shut-off valve for the water circulation and jet systems must be located five feet from the hot tub and must be seen from it.
Word to the Wise
If it’s wiring and lights, it can’t be within 5-10 feet of the hot tub. The hot tub shouldn’t be beneath power lines, either. Trust the professionals at Hammond Services to install your hot tub properly and safely. Contact us at website for more information.
